How to Add the e-Hub to the App

Available for Smart Version only, for direct app control via phone.

1. Power on the e-Hub and press and hold the Reset button for 5 seconds. Both LEDs will light up.

2. Press and hold again for 5 seconds, and only the green LED will flash rapidly.

3. Open the Smart Life app and click the “+” button in the top right corner to add the device. Select Others → WiFi Connector, and follow the instructions on your phone.

How to Add the Q20 Thermostat to the Smart Life App

1. Turn off the thermostat, then press and hold the M button until the pairing code appears on the screen. Then, press the up button.

2. In the app, access the e-Hub → Add Subdivision → Sensor. The app will scan and add the thermostat.

3. Repeat the procedure for each device.

How to Add the Q30 Thermostat to the Smart Life App

Note: Before adding the Q30 thermostat to the app, make sure the e-Hub Q20 gateway is already added.

1. Open the app, access the gateway, and click Add Subdivision → Thermostat.

2. Keep the thermostat on and press and hold both the O and UP buttons for 5 seconds to enter pairing mode. Then, press the button to enter the pairing process.

3. When the WiFi icon stops flashing, pairing is complete.

If You Can’t Add the Device, Please Check the Following:

• Ensure the Qsmart smart device is powered on.

• Ensure your phone is connected to a 2.4G Wi-Fi network.

• Check your router or connections: if your router is dual-band, select the 2.4G Wi-Fi network to connect your phone and the smart power device.

Attention!
If your router automatically switches from 2.4GHz to 5GHz, for the first connection, move as far away from the router as possible so it broadcasts the 2.4GHz signal, and then pair the device.

Once you enter the Wi-Fi password, the system may take a few seconds to connect. If you can’t add the device using the quick setup, use the “How to Add a Device in AP Mode”.